![]() ![]() Change from “Solid View” to “Layer View”.Press “Prepare” in lower right hand corner.I also changed the ironing pattern to “concentric” and ironing speed to 60 mm/s. In the “custom” panel, under “Shell” click “Enable Ironing” and then “Iron only highest layer” when that checkbox appears.This isn’t common when making a 3D file but you need a solid fill for these plates.On right hand side, change layer height to.2mm, I had to hop in and make that change in Cura as well. Make sure all your settings are correct under “printer settings.” When I swapped out my.Open Cura, start a new project and open your.Group your art file with the plate baseħ.For this file I used “holes” to cut off excess bits of plate, but it’s not necessary. 65 mm, then scale to be just slightly larger than your art file. (I’ve moved on to creating outlines of my art to use as the base, but trust me this is easiest for now and you can always cut down the base with scissors after the fact.) Use the square tool in TinkerCad and change the height to. When you’re starting out, it can just be a rectangle plate that goes behind the art file.This one will end up being about 3.5 inches square. ![]() Just like in Illustrator, holding down the “shift” key will maintain your aspect ratio. Everything in 3D printing is in millimeters, which I just am too American for, so I am on Google running conversions to inches all the time.I came to this number by using electronic calipers to measure the standard plates that came with my L Letterpress.Change the height of the art file to 1.8 mm.This can be anything! I used something I lettered in Procreate, but you can use honestly anything your little heart desires.If you don’t, your lettering or art will be backward. Don’t forget, like I did, to flip the image. I’m not remotely qualified to tell people how to use a 3D printer, I’m learning! But here are the steps you need to know to successfully print a letterpress plate. I have to say again, I’m assuming you already know the basics here. From this point on, I am assuming you know all of these things!  3D-ifying your art file with TinkerCad I’ve estimated the costs but some depend on what you buy or change frequently on Amazon, but it should give you a good idea.Īlso before we get started, check out these resources if you need to know the basics of lettering with Procreate on the iPad Pro, vectorising your Procreate art with Adobe Illustrator, printing with the L Letterpress or using a 3D printer. Here’s a breakdown of the equipment and software skills necessary so you don’t feel drawn in only to realize there is hundreds of dollars of equipment you still need to buy. I already had a lot of this on hand from other projects, so it didn’t feel so steep. You need to know design and 3D print basics, although I’ll provide resources for more on those topics. This tutorial is not for beginners of any kind. I’ll start with a preface: I am certain I am not the first person to think 3D print custom letterpress plates, but I had a hard time finding a full tutorial on the process top to bottom. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |